GE Industrial Solutions HE300GEN150 User Manual
Page 10
MAN0373-01 13 APR 2000 PAGE 11
CH.2
CHAPTER 2: INSTALLATION
2.1
Installation Procedures for the Option Card (GEN150)
The option card is designed to be mounted to the AF-300 drive in the same location as the keypad. The
same mounting instructions found in the GE FUJI AF-300 Drive Instruction Manual(s) for mounting the
keypad to the drive are also used for mounting the option card to the drive. The keypad is, then, mounted
to the option card. (Reference numbers for the drive instruction manuals are found in Section 1.5 in this
manual.)
The following are the necessary steps for installing the option card:
1.
Power down the drive.
2.
Remove the keypad from the top cover.
3.
Mount the option card in the same location where the keypad was removed. (Securing the two
screws, one in the upper left and the other in the lower right).
4.
Mount the keypad to the option card. (Securing the two screws, one in the upper left and the
other in the lower right).
5.
Connect the removable terminal strip with the Genius field wiring to the option card.
6.
Power up the drive as needed.
Figure 2.1 shows an example of how the option card is installed in an under 40 Horsepower drive.
Figure 2.1 - Example Installation in an Under 40 Horsepower Drive