GE Industrial Solutions AF-300 C11 - Manual (Page 22)

-20-
! CAUTION
1. Noise is generated from the drive, motor, and wiring. Take care that
this noise does not cause malfunctions in peripheral sensors and
equipment, otherwise accidents could occur.
(4) Control terminal arrangement, screw size, and tightening torque
Figure 2-3-7 shows the control terminal block arrangement.
Screw size: M2.5 Tightening torque: 3.5 lb ·inch ( 0.4 N· m)
Figure 2-3-7 Control terminal block arrangement
(5) Remove the plate at the bottom of the surface cover before performing drive control wiring and rein-
stall it after the wiring as shown in Figure 2-3-8.
Figure 2-3-8 How to pull out the control wiring
FM 30C 30B 30A X3 X2 X1 11 CM REV FWD C1 13 12
Plate Control wiring