Asus WL-320gE - Manual (Page 42)

3. Software
2 ASUS 802.11g Access Point
Chapter 3 - Software Configuration
W
eb (Common)
3.11.1 Firmware Upgrade
This page reports the Flash Code (Firmware) version installed in the ASUS
802.11g AP. Periodically, a new Flash Code is available for the ASUS 802.11g
APs on ASUS’s Web site. You can update the ASUS 802.11g AP’s Flash
Code using the Firmware Upgrade page under the Advanced Setup menu
of the Web Manager. If you are experiencing a problem with your ASUS
WLAN equipment, a Technical Support representative may ask you to give
your device’s Flash Code (Firmware) version.
Note: The firmware upgrade takes approximately 60 to 90 seconds.
When the firmware upgrade is completed, you will be directed to
the home page.
3.11.2 SNMP (in AP mode)
SNMP is a popular network monitoring and management protocol. It
provides network
administrators with the ability to monitor the status of the Access Point and
receive
notification of any critical events as they occur on the Access Point. You
can setup AP property for SNMP control needed in System Setup-> SNMP
webpage then click Save to apply your change.