Asus K8N-DRE - Manual (Page 89)

A S U S K 8 N - D R E A S U S K 8 N - D R E A S U S K 8 N - D R E A S U S K 8 N - D R E A S U S K 8 N - D R E 4 - 3 1 4 - 3 1 4 - 3 1 4 - 3 1 4 - 3 1
Change Supervisor Password Change Supervisor Password Change Supervisor Password Change Supervisor Password Change Supervisor Password
Select this item to set or change the supervisor password. The Supervisor
Password item on top of the screen shows the default N o t I n s t a l l e d
N o t I n s t a l l e d N o t I n s t a l l e d N o t I n s t a l l e d N o t I n s t a l l e d.
After you set a password, this item shows I n s t a l l e d I n s t a l l e d I n s t a l l e d I n s t a l l e d I n s t a l l e d.
To set a Supervisor Password:
1. Select the Change Supervisor Password Change Supervisor Password Change Supervisor Password Change Supervisor Password Change Supervisor Password item, then press <Enter>.
2. From the password box, type a password composed of at least six
letters and/or numbers, then press <Enter>.
3. Confirm the password when prompted.
The message “Password Installed” appears after you successfully set your
password.
To change the user password, follow the same steps as in setting a
supervisor password.
To clear the supervisor password, select the Change Supervisor Change Supervisor Change Supervisor Change Supervisor Change Supervisor
Password Password Password Password Password then press <Enter>. The message “Password Uninstalled” appears.
4.6 Security menu
The Security menu items allow you to change the system security settings.
Select an item then press <Enter> to display the configuration options.
V00.00 (C)Copyright 1985-2004, American Megatrends, Inc.
BIOS SETUP UTILITY
Main Advanced Server Security Boot Exit
Supervisor Password : Not Installed
User Password : Not Installed
Change Supervisor Password
→← →← →← →← →← Select Screen
↑↓ ↑↓ ↑↓ ↑↓ ↑↓
Select Item
+- Change Field
Tab Select Field
F1 General Help
F10 Save and Exit
ESC Exit
Install or Change the
password.
If you forget your BIOS password, you can clear it by erasing the CMOS
Real Time Clock (RTC) RAM. See section “2.6 Jumpers” for information
on how to erase the RTC RAM.