Asus P5MT-MX/C - Manual (Page 78)

4-20 Chapter 4: BIOS setup
4.4.3 Remote Access Configuration
The items in this menu allow you to configure the Remote Access features.
Select an item then press <Enter> to display the configuration options.
Configure Remote Access type and parameters
Remote Access [Disabled]
Select Remote Access
type.
Remote Access [Disabled]
Enables or disables the remote access feature.
Configuration options: [Disabled] [Enabled]
The succeeding items appear only when the item Remote Access is set
to [Enabled].
Serial port number [COM1]
Sets the serial port for console redirection. Make sure the selected port is
enabled. Configuration options: [COM1] [COM2]
Base Address, IRQ [3F8h, 4]
Sets the base address and IRQ assignment of the selected serial port . This
item is auto-detected and is not user-configurable.
Serial Port Mode [115200, 8,n,1]
Allows you to select the serial port mode settings.
Configuration options: [115200 8,n,1] [57600 8,n,1] [38400 8,n,1]
[19200 8,n,1] [09600 8,n,1]
Flow Control [None]
Allows you to select the flow control for console redirection.
Configuration options: [None] [Hardware] [Software]
Redirection after BIOS POST [Always]
Sets the redirection mode after the BIOS Power-On Self-Test (POST).
Some operating systems may not work when you set the item to [Always].
Configuration options: [Disabled] [Boot Loader] [Always]
Terminal Type [ANSI]
Allows you to select the target terminal type.
Configuration options: [ANSI] [VT100] [VT-UTF8]