Asus P9D-MH/SAS/10G-DUAL - Manual (Page 124)

5-20 Chapter 5: RAID configuration
3. Select a channel and press <Enter> to enter the setup.
The numbers of the channel depend on the controller.
5.4.1 RAID 1 volume
The RAID 1 feature supports simultaneous mirrored volumes with two disks.
The RAID 1 feature supports hot swap capability, so when a disk in an RAID 1 volume fails,
you can easily restore the volume, and the swapped disk is automatically re-mirrored.
To create a RAID 1 volume:
1. Turn on the system after installing all SAS hard disk drives.
2. During POST, press <Ctrl>+<C> to enter the SAS configuration utility.
LSI Corporation MPT SAS2 BIOS
MPT2BIOS-7.29.00.00 (2012.11.12)
Copyright 2000-2012 LSI Corporation.
Press Ctrl-C to start LSI Corp Configuration Utility...
To avoid data loss, do not turn off the system when rebuilding.
Esc = Exit Menu F1/Shift+1 = Help
Alt+N = Global Properties -/+ = Alter Boot Order Ins/Del = Alter Boot List
LSI Corp Config Utility v7.29.00.00 (2012.11.12)
Adapter List Global Properties
Adapter PCI PCI PCI PCI FW Revision Status Boot
BUS Dev Fnc Slot Order
Asus SAS2308-2 04 00 00 07 5.00.00.00-IR Enabled 0