Xoro HTC 1926D - Manual (Page 75)

13
Engl
ish
1. Connect the stand in order to the instruction on the previous page.
2. Connect the aerial or input source to the appropriate input socket at the rear of the set.
3. Connect the small round plug on the power adaptor cable to the power input socket at
the rear of the set.
4. Connect the main cable between the power adapter and the main supply. The LED will
show a red light.
5. Switch the power on by pressing the POWER button on the front panel or the remote
control. The LED will show a green light.
6. Use the SOURCE button on the front panel or the remote control and a popup window
with the sources appears on the screen. You can select following sources:TV, PC-RGB,
YUV, S-Video, SCART, DTC or DVD. You can use the front panel control to adjust the
volume or select a channel, as shown below, or you may use the remote control and
confirm by OK button.
A. Analog TV tuner (for example: cable system)
After switched on and press the SOURCE button and choose “TV” by pressing the
navigation button UP/DOWN and confirm by the OK button. Now the HTC xx26D
is in TV Mode. By the first using of the TV set, the systems starts automatically the
menu for searching the TV channels (please refer page 22).
B. DVD-Player:
Switch on the unit and press the SOURCE button and choose “DVD” by pressing
the navigation button UP/DOWN and confirm by the OK button. Now the HTC
xx26D is in DVD Mode.
C. DVB-T mode:
Switch on the unit and press the SOURCE button and choose “DTV” by pressing
the navigation button UP/DOWN and confirm by the OK button. Now the HTC
xx26D is in DVB-T mode. By the first using of the TV set, the systems starts auto-
matically the menu for searching the TV channels (please refer page 22).
6. To switch the set off a short time, press the POWER button, the set will go into stand-by
and the LED will show red . lf you are not going to use the set for some time, switch the
power off completely by unplugging the mains cable.
Quickstart Guide