Asus K8N-LR - Manual (Page 69)

ASUS K8N-LR 4-15
PIO Mode [Auto]
Selects the PIO mode.
Configuration options: [Auto] [0] [1] [2] [3] [4]
SMART Monitoring [Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology.
Configuration options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Disabled]
Enables or disables 32-bit data transfer.
Configuration options: [Disabled] [Enabled]
4.3.5 IDE Configuration
The items in this menu allow you to set or change the configurations for
the IDE devices installed in the system. Select an item then press <Enter>
if you wish to configure the item.
DISABLED: disables
the intergrated IDE
Controller.
PRIMARY: enables
only the Primary IDE
Controller.
SECODARY: enables
only the Secondary
IDE Controller.
BOTH: enables both
IDE Controllers.
IDE Configuration
OnBoard PCI IDE Controller [Both]
SATA0 IDE Interface [Enabled]
SATA1 IDE Interface [Enabled]
Hard Disk Write Protect [Disabled]
IDE Dectect Time Out (Sec) [35]
ATA(PI) 80Pin Cable Detection [Host]
First Boot Device from [P-ATA]
Configuration nVidia RAID ROM
OnBoard PCI IDE Controller [Both]
Enables or disables any or both the primary and/or secondary IDE
controllers. Configuration options: [Disabled] [Primary] [Secondary] [Both]
SATA0 IDE Interface [Enabled]
Enables or disables the SATA0 IDE Interface.
Configuration options: [Disabled] [Enabled]
SATA1 IDE Interface [Enabled]
Enables or disables the SATA1 IDE Interface.
Configuration options: [Disabled] [Enabled]
Hard Disk Write Protect [Disabled]
Enables or disables the hard disk wirte protection. This will be effective
only if device is accessed through BIOS.
Configuration options: [Disabled] [Enabled]