Asus RS520-X5/PS8 - Manual (Page 34)

Chapter 2: Hardware setup 2-16
8Mb
FWH
ATXPWR1
FLOPPY1
Z7
BUZZER1
COM2
Super
I/O
CR2032 3V
Lithium Cell
CMOS Power
PANEL1
PS/2
T: Mouse
B: Keyboard
USB12
ATX12V1
CPU_FAN1
Intel ®
6321ESB
PSUSMB1
AUX_PANEL1
HDLED1
USB34
LAN_BW1
LPT1
DSBV
-DX/SAS
Intel
®
5000V
PCIE4
DIMM_00 (64/72 bit, 240-pin module)
26.7cm (10.5in)
30.5cm (12in)
COM1
VGA1
PCIX1
PCI3
REAR_FAN2
PRI_IDE1
FRNT_FAN2
SGPIO1
RECOVERY1
VGA_EN1
LAN_EN1
RJ-45
(LAN2)
DIMM_01 (64/72 bit, 240-pin module)
DIMM_02 (64/72 bit, 240-pin module)
DIMM_10 (64/72 bit, 240-pin module)
DIMM_11 (64/72 bit, 240-pin module)
DIMM_12 (64/72 bit, 240-pin module)
CPU1
CPU2
FRNT_FAN1
FRNT_FAN4
CPU_FAN2
REAR_FAN1
CLRTC1
FAN_SEL1
SAS1 SAS2 SAS3 SAS4
Intel ®
82563EB
LED1
SB_PWR1
PCIX2
PCIE5
RJ-45
(LAN1)
SASLED1
SAS_EN1
SATA4
SATA5
SATA6
SAS
5
SAS
6
SAS
7
SAS
8
FRNT_FAN3
SATA1
SATA2
SATA3
FBD_FAN1
LSI1068
SGPIO2
2.6 Cable connections
Pre-connected system cables
1. 24-pin SSI power connector (from power supply to motherboard)
2. 8-pin SSI power connector (from power supply to motherboard)
3. System fan connectors (from motherboard FRNT_FAN4, FRNT_FAN1,
CPU_FAN1 and CPU_FAN2 to system fans)
4. USB connector (from motherboard to front I/O board)
5. Panel connector (from motherboard to front I/O board)
6. SATA connectors (from motherboard to slim optical drive)
7. SAS connectors (from motherboard to SATAII/SAS backplane board)
8. Auxiliary panel connector (from motherboard to front I/O board)
1
4
2
3
• The bundled system cables are pre-connected before shipment. You do
not need to disconnect these cables unless you will remove pre-installed
components to install additional devices.
• Refer to Chapter 4 for detailed information on the connectors.
7
6
8
3
3
5
3