Asus AP140R-E1 - Manual (Page 111)

ASUS AP1600R-E2 (AA2/AI2) 6-19
6.1.4.6 6.1.4.6 6.1.4.6 6.1.4.6 6.1.4.6 Rebuilding a RAID set Rebuilding a RAID set Rebuilding a RAID set Rebuilding a RAID set Rebuilding a RAID set
The utility displays the condition of the RAID set during the POST. When a
RAID set is degraded, you can use the utility to rebuild it.
To rebuild a RAID array:
1. Enter the Adaptec RAID Configuration Utility following the instructions
in the section “Creating a RAID 0 (Stripe).”
2. Select Array Configuration Utility from the initial menu, then press
<Enter>.
Check the physical connections of the SATA hard disk drives before you
rebuild a degraded RAID set. Check the system and motherboard user
guide for additional information.
3. From the main menu, highlight Manage Arrays, then press <Enter> to
display the installed RAID sets.
4. Highlight the degraded RAID set, then press <Enter> to display the
array properties. The Array Status shows DEGRADED.