Asus Z8PE-D18 - Manual (Page 87)

ASUS Z8PE-D18 4-27
Restore on AC Power Loss [Last State]
When set to [Power Off], the system goes into off state after an AC power loss.
When set to [Power On], the system will reboot after an AC power loss. When set
to [Last State], the system goes into either off or on state, whatever the system
state was before the AC power loss.
Configuration options: [Power Off] [Power On] [Last State]
Resume On Ring [Disabled]
When set to [Enabled], the system enables RI to generate a wake event while the
computer is in Soft-off mode. Configuration options: [Disabled] [Enabled]
Resume On PME# (Wake On LAN) [Disabled]
When set to [Enabled], the system enables the PCI-E and PCI-X to generate a
wake event while the computer is in Soft-off mode.
Configuration options: [Disabled] [Enabled]
Resume On RTC Alarm [Disabled]
Allows you to enable or disable RTC to generate a wake-up event.
Configuration options: [Disabled] [Enabled]
The following items appear only when the Resume On RTC Alarm item is set
to [Enabled].
RTC Alarm Date [15]
To set the alarm date, highlight this item and press the <+> or <-> key to
make the selection.
System Time [12:30:30]
Use the <ENTER>, <TAB> or <SHIFT-TAB> key to select a field. Use the <+>
or <-> key to configure alarm time.
4.4.6 APM Configuration
v02.61 (C)Copyright 1985-2008, American Megatrends, Inc.
Power On Configuration
Restore on AC Power Loss [Last State]
Resume On Ring [Disabled]
Resume On PME# (Wake On LAN) [Disabled]
Resume On RTC Alarm [Disabled]
←→ Select Screen
↑↓ Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
BIOS SETUP UTILITY
Advanced
Options
Power Off
Power On
Last State