Asus SL1000 - Manual (Page 142)

Chapter 12. System Management Internet Security Router User ’s Manual
126
address of time servers and the desired update interval. Select your time zone from the “Time Zone” drop-
down list, change the IP address of the time servers and the update interval if desired and then click on
button to save the changes.
12.4.1 View the System Date and Time
To view the updated system date and time, log into Configuration Manager as admin, click the System
Management menu, and then click the Date/Time Setup submenu.
12.5 System Configuration Management
12.5.1 Reset System Configuration
At times, you may want to revert to factory default settings to eliminate problems resulted from incorrect
system configuration. Follow the steps below to reset system configuration:
1. Log into Configuration Manager as admin, click the System Management menu, click the
Configuration submenu and then click the Default Settings submenu. The Default Settings
Configuration page displays, as shown in Figure 12.5.
2. Click on button to set the system configuration back to factory default. Note that the
Internet Security Router will reboot to make the factory default configuration in effect.
Figure 12.5. Default Setting Configuration Page
Sometimes, you may find that you have no way to access the Internet Security Router, e.g. you forget your
password. The only way out in this scenario is to reset the system configuration to the factory default by
following the procedures below using the reset switch:
1. Power down the Internet Security Router and wait for at least 5 seconds.
2. Power on the Internet Security Router and wait for at least 5 seconds before pressing the reset
switch the first time. You will see the Alarm LED flash once in about 5 seconds.
3. When you see the Alarm LED flash once, press the reset switch again. You will then see the
Alarm LED flash twice in about 5 seconds. This indicates that the Internet Security Router is
about to revert to the factory default settings. If you change your mind, you may press the reset
switch again or turn the power off to cancel this action.