Asus PIKE 2208 - Manual (Page 13)

ASUS PIKE 2208 1-5
1. Locate the PIKE RAID card slot on
the motherboard then remove the
screws beside PIKE1 connector as
shown.
2. Align the golden fingers of the RAID card with the PIKE RAID card slot then
Insert the RAID card into the card slot. Ensure the card is completely inserted
into the card slot, and the heatsink latch is completely hooked to the edge of
the card slot.
1.5 Card installation
Follow below instructions to install the RAID card to your motherboard.
3. Secure the PIKE RAID card with
the screw that you removed earlier.
DO NOT overtighten the screw,
or the motherboard component
can be damaged.
4. Connect the hard disk drives
to the SAS connectors on the
motherboard.