Air Suspension C-2518 REV 2 User Manual
Page 16
16
REV
2
06/03/2014
C-2518
C-2518
ARNOTT COil spRiNg CONVERsiON kiT
FOR
2003-2005
lAND ROVER RANgE ROVER
3.
disconnect the connector on the clocK BY pUlling on it. there is no taB to Be pUshed;
the locK will disengage itselF. (FigUre 50-3)
4.
plUg the clocK’s connector into the electronic BYpass ModUle and plUg the electronic
BYpass ModUle connector into the clocK. (FigUre 50-4)
FigUre 50-3
FigUre 50-4
5.
secUre the electronic BYpass ModUle Using electrical tape or doUBle-sided tape. iF
not place the Unit Behind the center console, re-install center console.
6.
iF the air sUspension control ModUle is still installed in YoUr vehicle reMove FUse 57
in the passenger FUse BoX (located in glove BoX).
7.
installation coMplete. start the engine and veriFY that the “sUspension inactive”
Message is not illUMinated on the inForMation center.