Armasight NYX-7 PRO GEN 2+ ID Night Vision Bi-Ocular - Manual (Page 18)

18
Install the AA battery as follows:
1. Unscrew the battery cap (A).
2. Unscrew the battery adapter (C) from the cap, turn it around, and screw in the other end.
3. Insert the AA battery (D), observing the polarity markings as indicated on the body of the device.
4. Screw the battery cap (A) back into place.
3.1.2 MOUNTING THE NYX-7 PRO TO A GOGGLE KIT
Mount the Nyx-7 PRO to the optional goggle kit as follows:
1. Put on the goggle kit. Adjust the goggle kit strap pads until the goggles fit securely around your
head. Remove the goggle kit.
2. Loosen the screw (A). While pushing down on the button (B), insert the Nyx-7 PRO rail into the guide
(C) of the goggle kit bracket. Tighten the screw (A).
3. Put on the goggle kit, now mounted with the Nyx-7 PRO.
4. To adjust the equipment for greater comfort, loosen the screw (A) and move the unit along the guide (C).
5. The goggle kit has a flip-up mechanism. Push the button (D) of the goggle kit bracket and lift the unit
up until it reaches its topmost position.
6. Push the same button (D) to lower the unit into the correct viewing position.
7. Push the button (E) and move the unit along the slide-rail (F) until the most comfortable position is
reached.
8. To remove the Nyx-7 PRO from the goggle kit, loosen the screw (A), push the button (B), and slide the
unit out of the bracket guide (C).
The Nyx-7 PRO contains Flip-up Shutoff System. This system turns the unit off when the Nyx-7 PRO is
upright on the flip-up head mount. The unit will automatically turn back on again for continuation of
the operation.
FIGURE 3-2. MOUNTING NYX-7 PRO TO A GOGGLE KIT
A
B
C
D
E
F