Armasight NYX-7 PRO GEN 2+ ID Night Vision Bi-Ocular - Manual (Page 19)

19
3.1.3 MOUNTING THE NYX-7 PRO TO A HELMET
An optional flip-up helmet mount can be used to attach the Nyx-7 PRO to a helmet. The helmet mount
fits the Nyx-7 PRO securely onto the helmet via a rugged strapping device and grooved hooks. With
the helmet mount, the Nyx-7 PRO can be positioned directly in front of the user’s eyes, or flipped back-
wards, out of the field of view.
Mount the Nyx-7 PRO to a helmet as follows:
1. Attach the mount to the helmet as shown in Figure 3-3.
2. Adjust and tighten the straps (A).
3. Loosen the screw (B). With the button (C) pushed down, insert the Nyx-7 PRO rail into the guide (D) of
the helmet mount bracket. Tighten the screw (B).
4. Put on the helmet with the Nyx-7 PRO attached.
5. Push the button (F) and move the unit along the slide-rail (G) until the most comfortable position is
reached.
6. To adjust the unit for comfort, loosen the screw (B) and move the unit along the guide (D).
7. Turn the lever (I) and move the unit along vertical slide-rail until the most comfortable vertical posi-
tion is reached.
8. To remove the Nyx-7 PRO and turn it around, push the button (E) and lift the unit up until it reaches
the topmost position.
9. Push the same button (E) to lower the Nyx-7 PRO into the proper viewing position.
10. To remove the Nyx-7 PRO from the helmet mount, loosen the screw (B), push down on the button
(C), and slide the unit out of the guide (D).
11. To remove the flip-up mechanism from the helmet mount, loosen the lever (I), pull the knob out (H),
and slide the flip-up mechanism out of the vertical rail.
The Nyx-7 PRO contains Flip-up Shutoff System. This system turns the unit off when the Nyx-7 PRO is
upright on the flip-up helmet mount. The unit will automatically turn back on again for continuation
of the operation.
FIGURE 3-3. MOUNTING THE NYX-7 PRO TO A HELMET
H
I
C
D
B
E
A
F
G