Armasight NYX-7 PRO GEN 2+ ID Night Vision Bi-Ocular - Manual (Page 23)

23
NOTE:
The IR illuminator is designed to provide additional illumination (when needed) while viewing
scenes or targets from a short distance (up to 3m).
1. To activate the IR illuminator, turn the unit on. Turn the function switch from ON to the IR position.
A red light will appear in the eyepiece to indicate that the IR illuminator is operating.
3.3.3 NYX-7 PRO SHUT-DOWN
1. Turn the function switch OFF. The green glow in the viewing area will fade to black.
2. Secure the lens cap over the objective lens.
3. If necessary, remove the unit from the rail (from the scope lens). Remove the unit by following the
mounting instructions in reverse.
4. Unscrew the battery cap and take out the battery. Replace the battery cap. Do not store the unit with
the battery still in it.
5. Store the unit and all accessories in the case.
3.4 STORAGE
Prepare the Nyx-7 PRO for storage as follows:
1. Verify that the Nyx-7 PRO and all accessories are clean and dry before returning them to the storage
case.
2. Secure the cap over the objective lens.
3. Remove the battery.
4. Place the Nyx-7 PRO and accessories in the appropriate locations in the case, and close the cover.