Armasight NAM601500126DH1 PVS14/6015 GEN 2+ HD Multi-Purpose Night Vision Monocular - Manual (Page 36)

36
(5) Ensure that the compass fits tightly to the objective lens.
(6) Refer to paragraph 3.4.6 for compass operation.
3.3.12. INSTALLATION OF THE 3X MAGNIFIER
The 3X magnifier can be threaded directly into the objective lens. It can also be threaded into the focus
ring adapter and slipped on over the end of the objective lens.
Figures 3-17 and 3-18 illustrate these installation procedures.
3.3.13. MOUNTING MUNVM TO A WEAPON WITH A qUICK-RELEASE PICAT-
INNY MOUNT ADAPTER
The MUNVM is mounted to a weapon with a quick-release picatinny mount adapter (QRM) using the
optional bracket.
Mount the MUNVM to the QRM as follows:
1. Loosen the bracket clamp screw (A, Figure 3-19).
2. Put the bracket clamp (B) onto infinity focusing stop ring (D) of the MUNVM objective lens.
3. Fix the MUNVM in the bracket clamp (B) by tightening the screw (A).
4. To unlock the clamping device (located on top of the QRM), see Figure 3-20. While pushing the lever
holder (C, Figure 3-20) down, turn the lever (B, Figure 3-20) towards the arrow (forward).
5. Install the MUNVM on the mount so that the stop (A, Figure 3-20) is inserted into the transverse slot
of the NVM rail.
6. Secure the MUNVM to the mount by turning the lever (B) to the locked position, as shown in Figure
3-20.
7. Verify that the clamping device is firmly secured to the MUNVM. If necessary, adjust the clamping
device.
MUNVM installed on the QRM is shown in Figure 3-21.
THREAD DIRECTLY INTO
OBJECTIVE LENS AS SHOWN
Figure 3-17. 3X Magnifier Installation
3X MAGNIFIER
FOCUS RING
ADAPTER
STEP 1 STEP 2
THREAD 3 X MAGNIFIER
INTO FOCUS RING ADAPTER
Figure 3-18. 3X Magnifier Installation with Focus Ring Adapter