AVSL Citronic CLA-1460 - Manual (Page 6)

171.220 User Manual
Multiple Flown Array
For multiple flown line-array, installation is similar to that
of a single array with sub cabinets coupled together and
passive units all flown in a single, longer array.
With the uppermost sub unit attached to its flying frame,
secure the 4 eyebolts for flying the array.
Subsequent sub units can be attached underneath
the topmost sub cabinet by connecting together the front
pulling plates and the upper and lower array brackets.
Connection of passive units from the bottom sub unit is
executed in the same way as for a single line array, with
each group of 4 passive units linked in a single line-array.
Split Array
The flying frame can also mount directly to the mid-top array cabinets via the front edge pulling
plates and connecting the Passive – Active link directly from the rear of the topmost array speaker to
the centre brace of the flying frame. Sub units can then be floor-standing and linked to 4 array
cabinets each with longer cables
Floor-standing Stack
Where flying or ceiling mounting is not possible, it may
be useful to arrange the CLA-1460 as a free-standing
stack on the floor or on a stage. In this orientation, the
sub unit sits on its flying frame on the floor and the
passive units are splayed upwards above the sub unit.
Prior to assembly, do not attach the 4 eyebolts to the
flying frame. If the frame is likely to damage the floor
surface, protect with rubber or other scratch-resistant
material, or it may be preferred to mount the frame on
castors for portability.
Assemble passive units above the sub in the same
manner as for a standard flown array shown above but
inverted. Splayed angle adjustment may be used for
venues with raised rear seating areas (e.g. theatres)