C2G 52041 TruLink VGA and PS_2 KVM - Manual (Page 10)

9
Installation
1. Important safety information regarding the
placement of this device is provided on page 5. Please review it
before proceeding.
2.
Make sure that power to all the devices you will be
connecting has been turned off. You must unplug the power cords
of any computers that have the Keyboard Power On function
.
Refer to the installation diagrams on the next page (the numbers
in the diagrams correspond to the steps indicated below) as you
do the following:
1. Plug the Console Adapter Cable into the Console Port
Connector on the rear panel of the switch.
2.
Plug your keyboard, monitor and mouse into their
respective connectors on the Console Adapter Cable. The
connectors are color coded and marked with an
appropriate icon for easy identification.
3.
Use the custom KVM cable sets (described in the Cables
section, page 4), to connect KVM Ports to the monitor,
keyboard and mouse ports of the computers you are
installing.
4.
If you choose to use external power, plug the power
adapter into an AC power source, then plug the power
adapter cable into the unit's Power Jack.
Note:
Under ordinary circumstances the switch doesn't require
external power. If, for some reason, you find that the quality
deteriorates (when using long cables, for example), you may want
to use the included power adapter. If you lose your power adapter
and need a replacement, the power adapter should be DC9V;
300mA, with the inside positive and the outside negative.
5.
Turn on the power to the computers.