Editing dns for static ip configuration – Acer Veriton N2620G User Manual
Page 16
16 | Virtual Appliance Installation & Setup
3
Enter the IP address to use as Echo's static IP and press OK.
4
Enter the subnet mask and then press OK.
5
Enter the gateway IP address and press OK.
6
Confirm the new static settings. Select Yes to apply the new
settings or, select No to discard these changes.
7
After selecting Yes, the network interface will restart and you will
be presented Echo's Main Menu.
Editing DNS for Static IP Configuration
When using a static address, you must edit the Echo server's
resolv.conf file. This file contains the IP address to your DNS server(s)
as well as domain search paths.
1
From the main menu, select Reconfigure Networks.
2
Select DNS view/edit resolv.conf.
3
Using the editor, make sure your file contains at least the following
two lines: search <domain> and namesever <ip address>
Where <domain> is your domain name and <ip address> is the
IP address of your DNS server.