Frequently asked questions – Acer P7203B User Manual

Page 48

Advertising
background image

48

En

gl

ish

Frequently asked questions

How do I configure the device network?

Auto-Configuration Network Setup: The default setting of APG is DHCP client. When

the APG is connected to a LAN that already has a DHCP server present, the APG takes

an IP address assigned to it by the server. When the APG is connected to a LAN that

does not have a DHCP server, the APG becomes the DHCP server in the network.

Why doesn't my device obtain an IP address automatically?

The device will ask for an IP address from your enterprise DHCP server while booting

up, however, sometimes it might fail to obtain an IP address in complex network

environments. The system will obtain the IP address again once there is another DHCP

server detected or you can configure your device IP address via Network Setup at Web

Admin.

How do I reset the APG to the factory setting?

Press the reset button and press the power button for 20 seconds to reset to factory

settings.

What do I do if I'm not redirected to the APG's web page automatically?

1. Make sure you have connected to the APG sucessfully.
2. Make sure your IP address is configured as Obtain an IP address automatically or

you have entered the proper IP address.
3. Turn off the proxy settings of your Internet browser.
4. Open your browser again.

What do I do if I can't enter the APG web page?

1. Make sure you have connected to the APG sucessfully.
2. Make sure your IP address is configured as to Obtain an IP address automatically or

you have entered the proper IP address.
3. Turn off the proxy settings of your Internet browser.
4. Open your browser again and you will be redirected to the APG's web page

automatically, or you can enter the device IP manually.

What can I do if I can't download the APG application?

1. Make sure you have connected to the APG sucessfully.
2. Make sure your IP address is configured as Obtain an IP address automatically or

you have entered the proper IP address.
3. Turn off the proxy settings of your Internet browser.
4. Open your browser again and you will be redirected to the APG's web

automatically, or you can enter the device IP manually.
5. Download.

Should I install the application again when upgrading firmware?

Yes. Download the application again and install it again.

What should I check for if I can't find the APG?

Is the PC connected to the APG properly?
Are there any personal firewalls enabled?
Due to your network or firewall settings, the client application may not be able to

connect to the projector server. Please check related settings to allow this application

to be able to communicate with the server!
To enable wireless projection, your personal firewall needs to allow the APG

Advertising