Xylem 2000 Series Frame Mounted Pumps AC8652 REV.C - Manual (Page 3)

DESCRIPTION
The Series 2000 Frame Mounted Centrifugal
Pump is an end suction centerline discharge
pump. The Series 2000 Pump’s rear pull out
construction makes servicing simpler and faster.
The hydraulically balanced impellers extend
bearing life and assure smoother, quieter
operation.
PUMP APPLICATION
The Series 2000 Pump’s available constructions
and sizes make it ideal for applications in general
industry, water supply, water transfer, condenser,
and chilled and hot water circulation.
SAFETY INSTRUCTIONS
SAFETY
INSTRUCTIONS
This safety alert symbol will be used in this manual
and on the pump safety instruction decals to draw
attention to safety related instructions. When used
the safety alert symbol means ATTENTION!
BECOME ALERT! YOUR SAFETY IS INVOLVED!
FAILURE TO FOLLOW THE INSTRUCTIONS
MAY RESULT IN A SAFETY HAZARD.
Your Series 2000 pump should have the following
safety instruction decals located approximately as
shown. If the decals are missing or are illegible
contact your local AC Fire Pump Systems
representative for a replacement. (Fig. 1)
ELECTRICAL SAFETY:
WARNING: Electrical Shock Hazard
Electrical connections to be made by a
qualified electrician in accordance with all
applicable codes, ordinances, and good practices.
Failure to follow these instructions could result in
serious personal injury or death, and property
damage.
WARNING: Electrical Overload Hazard
Three phase motors must have properly
sized heaters to provide overload and under
voltage protection. Single-phase motors have
built-in overload protectors. Failure to follow these
instructions could result in serious personal injury
or death, and property damage.
THERMAL SAFETY:
WARNING: Extreme Temperature
Hazard
If pump, motor, or piping is operating at extremely
high or low temperature, guarding or insulation is
required. Failure to follow these instructions could
result in serious personal injury or death, and
property damage.
MECHANICAL SAFETY:
WARNING: Unexpected Startup Hazard
Disconnect and lockout power before
servicing. Failure to follow these instructions could
result in serious personal injury or death, and
property damage.
WARNING: Excessive System Pressure
Hazard
The maximum working pressure of the pump is
listed on the nameplate, do not exceed this
pressure. Failure to follow these instructions could
result in serious personal injury or death, and
property damage.
WARNING: Excessive Pressure Hazard
Volumetric Expansion
The heating of water and other fluids causes
volumetric expansion. The associated forces may
cause failure of system components and release
of high temperature fluids. Installing properly sized
and located compression tanks and pressure relief
valves will prevent this. Failure to follow these
instructions could result in serious personal injury
or death, and property damage.
3