Xylem 19 001 200 R2 SILENT STORM VFD Pumping System - Manual (Page 8)

6
S = Submerged Sled pump assembly
M = Floating pump assembly
3. Pump Type:
C = Horizontal
S = Submersible
T = Vertical Turbine
M = Multi-stage Horizontal (ex. Goulds
SSV)
E = Submersible Trash Pump (ex. Ebara)
4. System Type:
P = Pump Station
T = Transfer
X = Control Package
5. System Gallons per Minute: If a multi-zone
system, show all zones with a slash ( / )
between each. If it is a control package,
show the total number of pumps to be
controlled.
6. Quantity of Pumps: Include pressure
maintenance pump and current pumps -
do not include future pumps in model
number.
7. System Pounds per Square Inch: If multi-
zone system, show all zones with a slash
( / ) between each zone. Design must
assume that all zones run at the same
time. Describe in no-uncertain terms the
performance of each zone. If the station
has spacing for future pumps, always
create a model number showing the
current conditions service. Make notes in
your documentation describing the
"current" versus "future" conditions of
service. On boosted systems, model
number should reflect the differential
pressure with notes describing the
incoming pressure.
HANDLING
Qualified personnel should unload and handle the
unit. Prevent damage due to dropping or jolting
when moving the unit. Thoroughly inspect the unit
for damage upon receipt. Immediately notify the
carrier of transportation damage. Ensure that
sensing lines are free of crimps and kinks.
The unit is top heavy due to the position of the
equipment. Do not use component eyebolts to lift
the pump station.
WARNING: Falling Objects Hazard
Eyebolts, if provided, are designed to lift only the
components to which they are attached.
Failure to follow these instructions could result in
serious personal injury, death, and/or property
damage.
STORAGE
During periods of storage, the unit should be
covered to prevent corrosion and contamination
from dirt. Store the unit in a clean, dry location to
prevent condensation and freezing. After storage,
check that it is dry before applying power. Specific
component storage instructions must be followed
in accordance with the respective equipment
manufacturer's recommendations.
CAUTION: Extreme Temperature Hazard
Extreme temperatures are to be avoided. (Below
32ºF and above 110ºF.)
Failure to follow these instructions could result in
serious property damage and/or moderate
personal injury.
FIELD CONNECTION DIAGRAMS
Actual equipment manufacturers/models installed
are system specific. Refer to specific
manufacturers’ Installation, Operation &
Maintenance Manuals for details unique to each
component. The pump instruction manual is
supplied with the system (if applicable).
Review the wiring diagrams and dimensional
drawings prior to unit installation and operation.
NOTE: Electrical supply must match the control
panel nameplate specification. Incorrect voltage
can cause fire, damaging electrical components
and void the warranty.
NOTE: Electrical supply must be installed by a
qualified electrician in accordance with all
applicable codes, ordinances, and good practice.