Xylem IM154 R01 AQUAVAR - Manual (Page 4)

3
AQUAVAR
Mounting Procedure
Components Included
(4) Screw M 5 x 60 (1) Thermal Resistor Cable Gland (4) Motor Mounting Clamp
Mounting
Gasket
4 screws
M5x50
Center bit
Transducer
Display
changeable
to 180º
Connection
motor
conduit box
Thermistor
4 mounting
clamps
Mounting:
• Remove the 3 screws from the
AQUAVAR cover.
• Place the center bit in the
AQUAVAR heat sink.
• Place the AQUAVAR on the motor.
• Hang the 4 clamps by the heat
sink and mount with the 4 screws.
• Mount the cover with the
3 screws (remember to use the
gaskets).
• Depending on pump orientation,
the display can be rotated 180º.