YSI Data Scout Advanced - Manual (Page 59)

YSI Incorporated Data Scout Advanced 55
The Averaging form specifies an averaging time in seconds (in the range 0 to 24). However, the time entry translates directly into an
equivalent sample count also shown in a un-editable text box. Setting a time of 0 seconds disables all averaging (i.e., set # of samples to
1). The value in the light green text box shows the current value of this option that was just read from the transducer. Click the text
box to edit the current value shown if you wish to change it. Click OK to accept the new averaging value or click Cancel to close the
form without saving changes.
The Configure | Pressure Units (HiLi Xdcr) menu item opens the following window:
Figure 4.40
The current Pressure Units are indicated by the option button selected. Select the desired Pressure Units by clicking the corresponding
option button. The user can change the pressure display precision (# digits to right of decimal point) by entering a value in the
Precision dialogue box. Click OK to send the changes to the Level Scout.
The Configure | Temperature Units (HiLi Xdcr) menu item opens the following window:
Figure 4.41
The current Temperature Units are indicated by the option button selected. Select the desired Temperature Units by selecting the
corresponding button and then click OK to change it units.