YSI IQ S ENSOR N ET NitraVis 70x IQ TS - Manual (Page 19)

NitraVis 70x IQ TS
Commissioning
3 - 9 ba75950e02 11/2012
3.4.3 Settings for the main sensor
Measuring cycle A measuring cycle consists of the cleaning procedure, the adjustment
time for the measuring system and the determination of the measured
value. The following graphic demonstrates the relevant settings:
Fig. 3-6 Measuring cycle of the UV-VIS sensor
Carrying out settings Using <S>, switch from the measured value display to the main menu
of the settings. Then navigate to the setting menu (setting table) of the
sensor. The procedure is described in detail in your IQ S
ENSOR
N
ET
system operating manual.
Default values are marked in bold.
Time
Adjustment time Measurement
Measuring
cycle
Measuring interval
Cleaning
Menu item Settings Explanations
Measuring mode

NO3-N
 NO3
The measured parameter is displayed
in the selected citation form.
Measuring location NitraVis 701 IQ TS :

Activation

Inlet

Outlet
NitraVis 705 IQ TS
:
 Outlet
(permanently set)
Measurement location or application of
the sensor.

The possible measurement loca-
tions are displayed depending on the
currently set measuring mode.
 The sample matrix on which the cal-
culation of the measured value is
based changes with the location of
the sensor.
Measuring range - Display of the measuring range
(see chapter 8 T
ECHNICAL DATA
).