Xylem H-2192 - Manual (Page 45)

> Speaks ‘Greater Than’
# Speaks ‘Number’
% Speaks ‘Percent’
& Speaks ‘and’
Other unique characters may speak a word or phrase but are normally unusable for this application
and can be spoken by spelling out the word if needed.
A - Alarm Message Menu:
Use option ‘A’ to enter the Alarm Message Menu to customize messages send during an alarm event.
Alarm messages are used only for outgoing calls and text messages and do not need any changes if
only incoming calls will be used.
5.5 Alarm Message Menu
This menu is used to setup the messages reported during an alarm event.
H-2191 Alarm Message Menu (ESC to Exit)
A - Alarm Message 1: Alarm 1
B - Alarm Message 2: Alarm 2
C - Alarm Message 3: Alarm 3
D - Alarm Message 4: Alarm 4
E - Alarm Message 5: Alarm 5
F - Alarm Message 6: Alarm 6
G - Alarm Message 7: Alarm 7
H - Alarm Message 8: Alarm 8
I - Alarm Message 9: Alarm 9
J - Alarm Message 10: Alarm 10
T - Ext Alarm Message: External Alarm
Enter Option ->
A - Alarm Message 1:
This is the message that will be used if an alarm 1 is triggered from the attached data logger.
The options B-J correspond to the remaining alarms 2 through 10.
T - Ext Alarm Message:
This is the message that will be used if an external alarm is triggered from the external alarm input
located next to the power connector.
Note: the alarm message also use the special control codes listed in the 5.4 Voice Menu section of
this manual.
H-219X
Menu Mode Reference 5-5