Xylem H-5223 - Manual (Page 82)

Parameters: There are two digital channels, so n can be either 1 or 2. For the trigger source,
this command expects an ASCII string. The trigger source can be “Stage”, “PSI”,
“Temp”, etc.
Response: None.
Example: -> DIGITAL1TRIGGERSOURCE=Stage 5 Command sent to XL™.
rs Response from XL™.
Command DIGITALnTRIGGERTYPE?
Description: Read the trigger type of the n th digital channel. The trigger type determines the
way in which the value of the trigger source is compared to the trigger point.
Parameters: There are two digital channels, so n can be either 1 or 2.
Response: An ASCII string is returned containing the trigger type. The trigger type can be
“Always”, “> Set Pt”, or “< Set Pt”.
Example: -> DIGITAL1TRIGGERTYPE? 5 Command sent to the XL™.
Digital 1 Trigger Type = Always rs Response from the XL™.
Command DIGITALnTRIGGERTYPE=
Description: Write the trigger type of the n th digital channel. The trigger type determines the
way in which the value of the trigger source is compared to the trigger point.
Parameters: There are two digital channels, so n can be either 1 or 2. For the trigger type, this
command expects an ASCII string. The trigger type can be “Always”, “> Set Pt”,
or “< Set Pt”.
Response: None.
Example: -> DIGITAL1TRIGGERTYPE=> Set Pt 5 Command sent to the XL™.
rs Response from the XL™.
Command DIGITALnTRIGGERPOINT?
Description: Read the trigger point of the n th digital channel. The trigger point is compared to
the value of the trigger source, and if the comparison meets the condition specified
H-5223
Remote Operation (Command Mode) C-23