Xylem Expert 800-900 - Manual (Page 23)

Manual
GB Manual Expert Log 800-900.doc
23
Initialization
Before communications with the Expert Log can be established, the latter needs to be initialized. This
is done by clicking on Read Contents. If a device is present, a table of all stored recordings is
displayed. The device type, serial number, device time and PC-time as well as the (total) memory
available in the device are listed in the status window. The status bar shows the current recording
status as well as the current time.
The menus
File
Exit: Exit the program
Port-Setup
Port: Selection of the serial interface
Modem: Upon activation, the communication protocol for data transfer via a modem is
negotiated.
Options
Configuration
General:
Setting the program language, activation/deactivation of auto detection of existing serial ports
(changes will take place only upon program restart). Another option is to delete all the "*.idc"-files
created when the program is exited. This should be set only if the memory available is very low.