Xylem MM 201H Series 67 and 767 Low Water Cut-Offs For Steam Boilers - Manual (Page 5)

h. Insert the tubing (Q) into the upper compres-
sion fitting (U) and tighten the fitting to 31 ft•lb
(42 N•m).
U
Q
g. Position the tubing (Q) next to the compression
fitting (K) and, using a pencil, mark the tubing
(Q) for proper insertion into the compression
fitting (K).
Remove the tubing (Q), and, using the tube
cutter, cut the tubing to its proper length.
Q
K
5
i. Using two (2) pipe wrenches, rotate the upper
tee (P) counterclockwise and the lower tee (J)
clockwise.
j. Place the compression nut (R) and the compres-
sion ring (S) over the bottom of the tubing (Q).
P
J
Q
S
R