Extron Electronics CD 100 User Manual
Page 6
4
CD100 / CD110 Court Director™ System Operation Manual - V. 1.0 11/30/00
© 2000 - INLINE, Inc.
4.) Connect the Audio Output Cables - to the appropriate pins on the CD100 5-pin
Phoenix connector. Make sure that the stereo audio output is connected appropriately for
a balanced or unbalanced signal as required by the installation (see the diagram below).
Unbalanced Output - connect to the Left, Right and Ground connectors.
Balanced Output - connect to Left +, Left-, Right+, Right- and Ground connectors.
5LJKW *URXQG
/HIW *URXQG
/HIW
5LJKW
8Q
EDO
DQ
FH
G
%D
OD
QF
HG
5LJKW *URXQG
/HIW *URXQG
/HIW
5LJKW
5LJKW
/HIW
5.) Connect the Remote Device - to the RS-232 input (see the Remote Operation Section on
page 10 for more information).
6.) Connect Optional Auxiliary Units - (IN1403 Scaler, IN3808 Switcher, etc.) to the
Auxiliary Input (Input 3).
7.) Connect All Video Sources / Computer Graphics Cards - to the appropriate CD100
15-Pin HD female input ports.
•
PC / MAC / SGI Computers with 15-pin HD Video Ports - can be connected via
IN8000-1 / IN8200-1 Series high-resolution coaxial VGA cables.
•
Older Macintosh (15-pin D) / SUN (13W3) / Workstations (4 or 5 BNC) - can be
connected using the appropriate input / output cables listed in the chart on the
following page.
An unused input does not need to be terminated.
8.) Connect the Computer Sound Card Output - (if applicable) to the 3.5mm female stereo
audio input connector using an IN8200-1 Series cable [15-pin HD with 3.5mm (M-M) mini
DIN], or an IN9106 audio patch cable (3.5mm stereo mini male to 3.5mm stereo mini male).
For computers with RCA connectors, use the IN9107 audio adapter cable [(1) 3.5mm stereo
mini male to (2) RCA male].
9.) Connect the Local Computer Monitor(s) - (if present) to the local monitor output
port(s) on the back of the CIA100. Monitors with 15-pin VGA connectors will attach
directly to the interface. For other types of monitors, refer to the table on the next page.
10.) Apply A/C Power - to the CD100 using the IN9230 IEC power cable (included).
11.) Turn on the CD100, the VGA source(s), the output device(s), the local monitor(s), and
any auxiliary devices.