Extron Electronics Annotator User Guide - Manual (Page 78)

I/O Configuration Tab
The I/O Configuration tab allows input and output configuration, as well as EDID
emulation settings to be adjusted.
Figure 38. The I/O Configuration Tab Screen
• Input Config — Set a suitable video type for an input by clicking on the drop-down
box (see input 7 above) and selecting a listed video type.
If Auto Image on an input is desired mark the check box.
Check Film Mode if 3:2 pull down detection for NTSC and 2:2 film detection for PAL
video sources is relevant.
• Output Config — To configure an output resolution, refresh rate, output type, or
sync polarity, select the desired values from the respective drop-down list.
• EDID Emulation — To set resolution and refresh rates for EDID emulation on the
VGA/DVI inputs, select the values from the drop-down list. Alternatively select Match
Output to automatically set the EDID to match the output resolution and refresh
rate.
Annotator • SPPCP 72