Extron Electronics DP DA2 User Guide - Manual (Page 15)

Front Panel Features
Power LED
The Power LED lights green when the unit is receiving power.
config usB Port
connecting to the usB Port
The mini type B USB port is located on the DP DA2 front panel. It can be used to connect
the distribution amplifier to a host computer for updating firmware or for configuration
using SIS commands. Alternatively, use the
RS-232 captive screw connector (see page
8). For complete information about SIS commands, see the “ SIS Commands ” section on
page 13.
1. Connect a USB A to mini B cable between the USB Config port on the front panel of
the DP DA2 and the USB port of the PC.
USB Cable
Type A
USB
Mini Type B
USB USB 1
USB
Ports
Computer
DP DA2 Front Panel
DP DA2
DISPLAYPORT DISTRIBUTION AMPLIFIER
INPUT OUTPUTS
1 2
SIGNAL
HDCP CONFIG
Figure 5. Connecting a PC to the DP DA2 Front Panel USB Port
DP DA2 • Panel Features 9