Extron Electronics DP DA2 User Guide - Manual (Page 26)

10. On the Add Device window, the path to the new firmware file is displayed in the Path
field.
Figure 12. Path to the New Firmware File on the Add Device Window
11. If this is the only device to which you are uploading firmware, click Add . The
DP DA2 information is added to the Devices section of the Firmware Loader window
and the Add Device window closes.
If you will be uploading the firmware to multiple DP DA2 units that are
connected to your computer, do the following:
a. Click Add Next . Your first device is added to the Devices section of Firmware
Loader window, and the Add Device window remains open.
b. For each additional device you want to add to the Firmware Loader window,
repeat steps
5 through 9, then click Add Next .
c. For the last device, click Add (instead of Add Next ) to add the device and to
close the Add Device window.
DP DA2 • Updating Firmware 20