Extron Electronics EDID 101H User Guide - Manual (Page 10)

EDID 101H • Installation 4
Front Panel Features
CONFIG
EDID 101H
Extron
SIGNAL
HDCP
IN OUT
1 2 3 4
Figure 3. EDID 101H Front Panel Indicators and Configuration Port
a
Power LED – Lights green when an external power supply is connected and powered.
b
Config port – Connect a host computer using a USB mini type-B connector for
configuration using SIS commands, and for firmware updates (see
Connecting to the
USB Port on page 16).
c
Signal In LED – Lights green when an HDMI signal is detected on the input.
HDCP In LED – Lights green when the source device requires HDCP encryption and
the signal has been authenticated.
d
Signal Out LED – Lights green when an active sink (display) device is connected to the
output.
HDCP Out LED – Lights green when HDCP is authenticated between the HDMI output
and the connected sink device. This occurs only when the source device requires
HDCP and is authenticated.
If the source does not require HDCP or if the sink device is not HDCP compliant, the
LED does not light.