Installation and operation, Rear panel features – Extron Electronics FOX DA8 Plus User Guide User Manual

Page 10

Advertising
background image

Installation and

Operation

The topics covered in this section are:

• Rear Panel Features
• Front Panel Features
• System Operation

Rear Panel Features

FOX DA8 Plus

100-240V 0.3A

OPTICAL OUTPUTS

A

B

C

D

OUT IN

1

OUT IN

3

OUT IN

5

OUT IN

7

(1)1x8

(2)1x4

(4)1x2

50/60 Hz

RS-232

Tx Rx

OUT N/A

4

OUT N/A

6

OUT N/A

8

OUT N/A

2

5

1

* See first

NOTE

, below.

3

3

4

2*

3

3

2*

3

3

2*

3

3

2

Figure 2.

FOX DA8 Plus Connectors

WARNING: Risk of serious physical injury: This unit outputs continuous invisible

light, which may be harmful to the eyes; use with caution. For additional
safety, plug the attached dust caps into the optical transceivers when the
fiber optic cable is unplugged.

NOTES:

•

Input LC connectors (on the right) marked with an asterisk (*) in figure 2

(inputs 3, 5, and 7) are functional only when selected as an input using the
DA configuration switch (

item d

). The connector on the right for transceiver

blocks 2, 4, 6, and 8 can never be functional.

•

Singlemode and multimode devices are not interchangeable. Ensure that

you connect transmitting and receiving devices that are compatible with the
FOX DA8 Plus.

•

Ensure that you use the proper fiber cable for your system. Typically,
singlemode fiber has a yellow jacket and multimode cable has an orange or
aqua jacket.

•

In this guide, the term “sending connector” refers to an LC connector on a
device that outputs a fiber optic signal. The term “receiving connector” refers
to an LC connector that receives an optical signal.

FOX DA8 Plus • Installation and Operation

4

Advertising