Extron Electronics FOX DA8 Plus User Guide - Manual (Page 11)

a
AC power connector — Plug a standard IEC power cord into this connector to connect
the FOX DA8 Plus to a 100 VAC to 240 VAC, 50-60 Hz power source.
b
Input connectors and LEDs —
OPTICAL
1 2*
* OPTIONAL FOR
RETURN DATA
LINK LINK
Transmitter
Receiver
DA
OPTICAL
2* 1
LINK LINK
2
3
A
OUT IN
1
NOTE: Input LC connectors (on the right) marked with an
asterisk (*) in figure 2 are functional only when selected as
an input using the DA configuration switch (
item d ). The
right-hand connector for transceiver blocks 2, 4, 6, and 8
can never be functional.
Optical transceiver Input connector — For one-way video, audio,
and serial communications from the transmitter to the FOX DA8 Plus for
distribution to the receivers, connect a fiber cable to the optical
transceiver input LC connector on transceiver block 1 ( the LC connector
on the right).
Connect the far end of this fiber optic cable to the sending connector on
the transmitter or another compatible Extron device.
Optical transceiver block 1 Input LED — When this LED is lit, the link
is active (light is received from the transmitter).
NOTE: The LEDs on the right for transceiver blocks 2, 4, 6, and 8
may light, but do not indicate that there is an input to that
connector.
c
Output connectors and LEDs —
Connectors — For one-way video, audio, and serial communications
from the FOX DA8 Plus to the receivers, connect up to eight fiber optic
cables to the output LC connectors on transceiver blocks 1 through 8.
Connect the far ends of these fiber optic cables to the receiving
connectors on the receivers or other compatible Extron devices.
LEDs — These LEDs are always lit, whether the output is active
(unmuted) or not.
d
DA configuration switch — Set this switch to configure the unit in
any of the following configurations (see “ Configuration “on page 8).
• One 8-output DA
(1)1x8 (2)1x4 (4)1x2
• Two 4-output DAs
• Four 2-output DAs
FOX DA8 Plus • Installation and Operation 5