Extron Electronics Fox Tx_Rx AV User Guide - Manual (Page 26)

Starting the Program
Start the Extron FOX Extender control program as follows:
1. Set up and power on the units as described in Power Input on page 5. Connect the PC
to one of the control ports on either the transmitter or receiver (see page 10).
2. Click Start > All Programs > Extron Electronics > FOX Extender
WCP > FOX Extender WCP or click on the desktop icon (see icon at right).
The Communication Setup window opens:
Figure 12. Communication Setup Window
3. Select the Com port to which your transmitter or receiver is connected and click
Connect . The Communication Setup window closes and the FOX Extender
Windows Control Program window opens (see figure 13 below).
Figure 13. FOX Extender Windows Control Program Window
FOX Tx/Rx AV • Configuration 20