Extron Electronics Fox Tx_Rx AV User Guide - Manual (Page 31)

Video input — transmitters
Number/signal type ........................ 1 component (Y, R-Y, B-Y), S-video, composite video
Connectors .................................... 1 x 3 female BNC or 1 female 4-pin mini DIN for S-video
Nominal level ................................. 1.0 Vp-p for Y of component video and S-video, and for composite video
0.7 Vp-p for R-Y, B-Y of component video
0.3 Vp-p for C of S-video
Minimum/maximum levels .............. Analog: 0.3 V to 1.5 Vp-p with no offset
Impedance ..................................... 75 ohms
Return loss ..................................... -30 dB for Y/VID, B-Y/C, R-Y @ 5 MHz
Input coupling ................................ AC
Video output — receivers
Number/signal type ........................ 1 component (Y, R-Y, B-Y) video, S-video, composite video
Connectors .................................... 1 x 3 female BNC or 1 female 4-pin mini DIN for S-video
Nominal level ................................. 1.0 Vp-p for Y of component video and S-video, and for composite video
0.7 Vp-p for R-Y, B-Y of component video
0.3 Vp-p for C of S-video
Minimum/maximum levels .............. 0.3 V to 1.5 Vp-p
Impedance ..................................... 75 ohms @ 5 MHz
Return loss ..................................... <-40 dB @ 5 MHz
DC offset ....................................... +350 mV, maximum, with input at 0 offset
Video delay .................................... 1-2 frames
Audio
Gain
Range ...................................... Adjustable, -18 dB to +10 dB
Default .................................... Unbalanced output: -6 dB; balanced output: 0 dB
Frequency response ........................ 20 Hz to 20 kHz, ±0.5 dB
THD + Noise ................................... 0.15% @ 1 kHz at nominal level
S/N ................................................. >80 dB at maximum output (unweighted)
CMRR ............................................ 65 dB @ 20 Hz to 20 kHz
Audio bits per sample ..................... 18 bits per channel, 2 channels (L, R)
Sampling rate ................................. 48 kHz
Audio input — transmitter
Number/signal type ........................ 1 stereo, balanced/unbalanced or
2 mono, balanced/unbalanced
Connectors .................................... (1) 3.5 mm captive screw connector, 5 pole
Impedance ..................................... >10k ohms unbalanced, >20k ohms balanced, DC coupled
Nominal level ................................. +4 dBu (1.23 Vrms), -10 dBV (316 mVrms)
Maximum level ............................... >+17 dBV, (unbalanced) at 1% THD+N
NOTE: 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu
Audio output — receiver
Number/signal type ........................ 1 stereo, balanced/unbalanced or
2 mono, balanced/unbalanced
Connectors .................................... (1) 3.5 mm captive screw connector, 5 pole
Impedance ..................................... 50 ohms unbalanced, 100 ohms balanced
Nominal level ................................. +4 dBu (1.23 Vrms), -10 dBV (316 mVrms)
Maximum level (Hi-Z) ...................... >+19 dBu, unbalanced at 1% THD+N
Maximum level (600 ohm) .............. >+15 dBm, unbalanced at 1% THD+N
Audio delay .................................... 1.5 frames
FOX Tx/Rx AV • Specifications 25