Extron Electronics IN1608 MA User Guide - Manual (Page 17)

IN1606 and IN1608 Series Scaling Presentation Switcher • Installation 11
h HDMI output connectors — Connect display devices to the HDMI connectors. Use
one of these connectors for a local monitor to display the On-screen Display (OSD)
menu (see
Operation on page 14).
TIP: Use Extron HDMI LockIt Lacing Brackets to secure HDMI cables to the device
(see HDMI Connections on page 12).
i Analog audio output connectors — Connect audio output devices to these 5-pole
captive screw connectors. Wire the connector for line level, balanced or unbalanced,
analog stereo.
Do not tin the wires!
Balanced Audio Output
Tip
Ring
Tip
Ring
Sleeves
Unbalanced Audio Output
Tip
No Ground Here
No Ground Here
Tip
Sleeves
LR LR
Figure 8. Audio Output Connector Wiring
h LAN connector — Connect a computer network to this RJ-45 connector. Use a patch
cable to connect to a switch, hub, or router. Wire the connector as shown below.
Pin T568A
Wire Color
T568B
Wire Color
1 White-green White-orange
2 Green Orange
3 White-orange White-green
4 Blue Blue
5 White-blue White-blue
6 Orange Green
7 White-brown White-brown
8 Brown Brown
LEDs on this connector indicate link and activity status.
i RS-232 connector — Connect a host device to this 3-pole captive screw connector
for RS-232 serial control. The default baud rate is 9600.
Do not tin the wires!
Controlling
Device
Ground (G)
Receive (Rx)
Transmit (Tx)
Ground (G)
Receive (Rx)
Transmit (Tx)
Bidirectional
Tx Rx G
RS-232
Figure 9. RS-232 Wiring
12345678
RJ-45
Connector
Insert Twisted
Pair Wires
Pins:
Pin
1
2
3
4
5
6
7
8
Wire color
White-green
Green
White-orange
Blue
White-blue
Orange
White-brown
Brown
Wire color
T568A T568B
White-orange
Orange
White-green
Blue
White-blue
Green
White-brown
Brown