Extron Electronics IN1608 MA User Guide - Manual (Page 41)

IN1606 and IN1608 Series Scaling Presentation Switcher • SIS Configuration and Control 35
X3! = Video switching effect 0 = cut
1 = fade through black (default)
X3@ = HDMI output format 0 = auto (based on the display EDID: default)
1 = DVI RGB 444
2 = HDMI RGB “Full”
3 = HDMI RGB “Limited”
4 = HDMI YUV 444 “Full”
5 = HDMI YUV 444 “Limited”
6 = HDMI YUV 422 “Full”
7 = HDMI YUV 422 “Limited”
X3# = Default name A combination of model name and the last three pairs
of the device MAC address (for example, IN1606-
07-8C-EC)
X3% = Audio input type 0 = none (input muted)
1 = analog (default for inputs 1 and 2)
2 = LPCM-2Ch digital (default for inputs 3-6)
3 = Multi-Ch digital
4 = LPCM-2Ch digital auto
5 = Multi-Ch digital auto
X3^ = Video signal status 0 = video or HDMI signal not detected
1 = video or HDMI signal detected
X3& = Power save mode 0 = full power mode (default)
1 = lower power state
X3* = Screen saver status 0 = active input detected, timer not running
1 = no active input, timer running, output sync
still active
2 = no active input, timer expired, output sync
disabled
X3( = HDCP authorization status 0 = block HDCP encryption
1 = allow HDCP encryption (default)
X4) = IP address xxx.xxx.xxx.xxx
( 192.168.254.254 = default)
X4! = Subnet mask xxx.xxx.xxx.xxx ( 255.255.0.0 = default)
X4@ = Gateway address xxx.xxx.xxx.xxx ( 0.0.0.0 = default)
X4# = MAC address 00-05-A6-xx-xx-xx
X4$ = Number of open
connections
0-<maximum number of open connections>
X4% = Config type 0 = IP config
1 = device-specific parameters
X4^ = Volume group number 1 = program volume
3 = mic volume
8 = variable volume
X4& = Group volume level -1000 to 0, where -1000 = -100 dB or 0% volume
and 0 = 0 dB or 100% volume
X4* = Mute group number 2 = program mute
4 = mic mute
7 = output mute
X4( = Bass and treble group number 5 = bass control
6 = treble control
X5) = Bass and treble level -240 to +120, where -240 = -24 dB and
+120 = 12 dB