Extron Electronics MGP Pro Series User Guide - Manual (Page 47)

MGP Pro Series • Operation 41
Reset Modes Summary
Mode Activation Result Purpose
1 Hold in the Reset button while applying
power to the MGP Pro. Restores the factory-installed firmware. It
does
not clear the current configuration.
Mode 1 can be
used to remove a
version of firmware
if incompatibility
issues arise.
3 Hold in the Reset button until
the Reset LED blinks once (after
approximately 3 seconds) Then, within
1 second, press Reset momentarily
(for less than 1 second). Turns events on or off. The Reset LED
blinks two times if events are starting or
three times if events are stopping. Mode 3 is useful
for troubleshooting.
4 Hold in the Reset button until the
Reset LED blinks twice (once after
approximately 3 seconds and
again after 6 seconds). Then, within
1 second, press Reset momentarily (for
less than 1 second). • Enables ARP capability.
• Sets the IP address, subnet address,
and gateway address to the factory
defaults.
• Sets port mapping to the factory
default.
• Turns DHCP off.
• Turn events off.
The Reset LED blinks four times in quick
succession during the reset.
Mode 4 enables
you to set
IP address
information using
ARP and the MAC
address.
It does not replace
any user-installed
firmware.
5 Hold in the Reset button until the
Reset LED blinks three times (once
after approximately 3 seconds, again
after 6 seconds, and then again after
9 seconds). Then, within 1 second,
press Reset momentarily (for less than
1 second). Performs a complete reset to factory
defaults (with the exception of the
firmware), which includes:
• Everything mode 4 does
• Reset of most real time adjustments:
• Clears all ties, presets, and video
settings.
• Resets all IP options.
• Removes or clears all MGP files.
The reset LED blinks four times in quick
succession during the reset.
Mode 5 is useful
if you want to
start over with the
configuration.
NOTE: Mode 5 reset clears most adjustments. To save these settings, use the MGP Series Control
Program and select Save/Restore Configuration from the File menu before you perform this
reset (see the control program help file for more information).
NOTES:
• The reset modes listed in the table above close all open IP and Telnet connections
and all sockets.
• Each mode is a separate function, not a continuation from mode 1 to mode 5.
• Reset mode 2 is not available on the MGP products.
• For reset modes 3, 4, and 5, nothing happens if the momentary press does not
occur within 1 second.
Use Factory Firmwar
e
Run or Stop Events
Reset All IP Settings
Reset to Factory Defaults