Extron Electronics MSG0603 - Manual (Page 6)

4
MSC0603 OPERATION MANUAL - v1.0 5/7/02

2002 - INLINE, INC.
Installation
Below are instructions for installing the MSC0603 Matrix Switcher. An application diagram
showing typical connections is on page 5.
Note: Prior to initiating the installation procedure, ensure that there is
no power supply cord connected to the unit.
1. Place/install the MSC0603 at the desired location. Seat the unit on a flat surface or
securely install it in a standard 19" equipment rack using the MTR102 rack ears
(provided). The MSC0603 is exactly 1U high without the feet. If other equipment will
be located in the space directly below the matrix switcher, you must remove the rubber
feet on the bottom of the unit before mounting it in the equipment rack.
2. Connect the output display devices (monitors, data projectors, etc.) to the matrix
switcher BNC connector outputs. The MSC0603 features three BNC composite video
outputs and three S-Video BNC S-Video outputs for easy connections to display devices.
You can connect display devices with a BNC input directly to the MSC0603 BNC output
ports using standard BNC cables. INLINE’s IN8000 Series flexible BNC cables offer
exceptional performance and are available in a variety of lengths.
3. Connect the MSC0603 analog stereo audio output (5-pin captive screw terminal) to the
audio system’s line level input (mixer, amplifier, powered speakers, etc.). The output can
be set for balanced or unbalanced output signal as required by wiring the output
appropriately (see wiring diagram below). The analog audio output connector will
accept stranded or solid cables from 20 - 26 AWG.
For Unbalanced Stereo Audio Output: For Balanced Stereo Audio Output:
4. Connect the input video sources to the matrix switcher’s BNC connector inputs.
5. Connect the audio sources to the audio inputs. All five inputs accept balanced or
unbalanced stereo audio signals. Connect the audio signals to the 5-pin captive screw
connectors.
6. If desired, connect a control system, computer, or other serial command source to the
RS-232 remote connector. Cable the control system or computer serial port to the serial
port based on the type of connection described on page 9.
7. Connect power to the Matrix switcher, display devices, and serial and audio equipment
as applicable. To connect power to the switcher, attach the power cord to the connector
on the rear of the set. A standard IEC power cord comes with the unit. Plug it into a 100
– 40 VAC, 50Hz or 60Hz power source.