Extron Electronics MS9200P - Manual (Page 82)

HD Player Chapter 12: Remote Control Protocols
82 Rev. 6.8
The Player will respond with:
OK or ERROR
Tcplayat <Channel list> <timecode>
Sets the timecode playat time
The Player will respond with:
OK or ERROR
Tcstopat <Channel list> <timecode>
Sets the timecode stopat time
The Player will respond with:
OK or ERROR
Tcstart <Channel list>
Starts the timecode running (assumes the player is in Generate mode – refer to “The Timecode configuration
dialog” section of Chapter 6: Timecode)
The Player will respond with:
OK or ERROR
Miscellaneous Commands – (Telnet Protocol)
Playfiles <Channel> <start chapter> <end chapter>
Load and play a range of files
Playlist <Channel>
Begins playback of the selected chapters. This command should normally follow a Playrange command.
Play <Channel>
Play the currently loaded file.
[When a file is playing the HD player will return this command:
Channel x Playing <cr> <lf> (where x is the base channel set in the channel properties) .]
[When a file has played the HD Player will return this command:
Channel x Playlist Complete <cr> <lf> (where x is the base channel set in the channel properties) .]
Note: The Play and Playlist commands are identical in the HD Player. Both are maintained for compatibility with
other Electrosonic Player products.
Seek <channel> <frameno>
Seek to a position in the file. Note: This will seek to the next closest index point (i.e. I frame) to the frameno
Add <Channel> <FileName>
Adds a file to the playlist of the requested channel.
Clear <Channel>