Extron Electronics MPX 866 A User Guide - Manual (Page 42)

Example 7: Saving a global preset
In the following example, the current configuration is saved as a preset. The steps show the
front panel indications that result from your action.
1. Clear all selections: Press and release the Esc button. The button flashes once.
2. Select Save Preset mode: Press and hold the Preset button for approximately 2
seconds until it blinks.
1 2 3 4
PRESET PRESET
COMPUTER/AUDIO OU
Press and hold the Preset button until the
Preset LED blinks.
Release the
Preset button.
2 seconds
All input and output LEDs with assigned presets light.
If you then save the configuration to a lit preset number,
the configuration data at that preset location will be overwritten.
Lit =
Preset Assigned
Unlit =
Preset Unassigned
Preset 15 Preset 16 Preset 18 Preset 17
3. Select the preset: Press and release the input button for the desired preset.
1 2 3 4
Preset 15 Preset 16 Preset 18 Preset 17
CONTROL
ENTER PRESET
COMPUTER/AUDIO OU
The Enter LED blinks to indicate
the need to save the preset.
The Preset LED continues to blink.
Press and release the Computer Output 1 button.
The LED blinks to indicate that this
preset
number is selected but not saved.
VIEW ESC
4. Confirm the change: Press and release the Enter button. The current configuration is
now stored in the selected memory location.
CONTROL
ENTER PRESET VIEW ESC
The Enter and Preset LEDs
return to the unlit state.
Press the Enter button to
save the preset.
All input LEDs
return to the
unlit state.
MPX 866 A Media Presentation Matrix Switcher • Operation 37