Extron Electronics MTP 15HD RS Series User Guide Rev. F - Manual (Page 21)

Maximum resolution ..................... Up to 1920x1200 or 2048x1080 or 1080p at 300'
Up to 1024x768 at 600'
NOTE: Refer to the user guide for the maximum distances recommended for specific resolutions.
Sync
Input type (transmitters) ................ RGBHV, RGBS, RGsB, RsGsBs
Output type (receivers) .................. RGBHV, RGBS, RGsB, RsGsBs
Standards ..................................... NTSC 3.58, NTSC 4.43, PAL, SECAM
Input level (transmitters) ................ 3.5 V to 5.5 Vp-p, unterminated
Output level (receivers) .................. 4.0 V to 5.0 Vp-p, unterminated
C7 models
Input impedance ....................... 573 ohms
Output impedance .................... 92 ohms ±8% (25 mA)
All other models
Input impedance ....................... 510 ohms
Output impedance .................... 110 ohms
Max. input voltage ........................ 5.5 Vp-p
Polarity
Transmitter ................................ Positive or negative (follows input polarity)
Receivers ................................... Positive or negative (switch selectable)
Control/remote — external device (pass-through, unidirectional or bidirectional)
Serial control port input/output
MTP C7 T 15HD RS, MTP T 15HD RS
RS-232 via (1) 3.5 mm, 3 pole captive screw connector
Receivers ................................... 1 set of proprietary signals on a female RJ-45 jack
Serial control port output/input
MTP C7 T 15HD RS, MTP T 15HD RS
1 set of proprietary signals on a female RJ-45 jack
Receivers ................................... RS-232 via a 3.5 mm, 3 pole captive screw connector
Baud rates .................................... Up to 38400 bps at up to 600' (183 m) (Higher data rates and distances are
possible. Performance varies based on baud rate and cable length.)
Protocol ........................................ Data bits = 5 - 8
Stop bits = 1 or 2
Parity = odd, even, none
Flow control = XON, XOFF, none
NOTE: Protocol is mirrored between the transmitter and the receiver.
Serial control pin configuration ..... Captive screw connectors: 1 = TX, 2 = RX, 3 = GND
General
Recommended cable type
C7 models ................................. Extron STP201 or CAT 7
All other models ........................ CAT 5/5e/6 (shielded or unshielded)
Power supply ................................ External
Input: 100-240 VAC, 50-60 Hz
Output: 12 VDC, 1 A, 12 watts
Power input requirements ............. 12 VDC, 0.5 A
Temperature/humidity ................... Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
Cooling ......................................... Convection, no vents
MTP 15HD RS Series • Reference Information 17