Step 7 — install the aap assembly, Step 8 — mounting the enclosure, Product category – Extron Electronics TLP Pro 720C Setup Guide User Manual
Page 5
5
Product Category
Step 7 — Install the AAP Assembly
1.
From under the table, push the first AAP assembly
through the bottom of the enclosure. The holes in the
rear bracket must align with the bottom row of holes on
the rear face of the enclosure.
TIP:
Ensure there is enough space above the AAP
assembly for the lid to close completely without
cables or connectors contacting the touchpanel.
2.
Secure the AAP assembly into position with the
provided Phillips head screws.
3.
Tighten the nuts that secure the AAPs to the brackets.
1
1
5
5
2
2
3
3
4
4
CO
MP
UT
ER
AU
DIO
Phillips Head Screws
(secure AAP
assembly)
Tighten down
AAP nuts.
Push assembly through
bottom of enclosure.
Large slot
provides tool
access to fasten
rear brackets.
1
1
2
2
3
3
Ex
tron
Step 8 — Mounting the Enclosure
Mount the cable cubby enclosure in the table.
CAUTION:
The flanged edges of the top of the surface enclosure are sharp. These edges are also soft and may be easily
nicked or bent. Exercise caution when handling the enclosure to prevent personal injury or damage to the enclosure.
ATTENTION:
Les extrémités à brides du haut de la surface du boîtier sont aiguisées. Ces extrémités sont aussi lisses
et peuvent facilement être coupées ou pliées. Soyez prudents lorsque vous manipulez le boîtier afin d’éviter de
l’endommager ou de vous blesser.
1.
Remove the edge grommet protecting the edges of the trim ring
and the plastic film on the finished surfaces.
ATTENTION:
Do not use isopropyl alcohol or other solvents
to clean the Cable Cubby. Strong solvents will ruin some
finishes.
ATTENTION:
Ne pas utiliser de l’alcool isoproprylique ou
d’autres solvants pour nettoyer le Cable Cubby. Les solvants
forts endommageront certaines finitions.
2.
Carefully lower the enclosure into the hole cut in the table (see
on page 3). Ensure the trim ring (
5
)
is flush with the top of the table.
3.
Under the table, attach the table clamps (
3
) to the pins on
each side of the enclosure. It may be necessary to loosen the
wingnuts (
1
) and the Phillips head screws (
2
).
4.
When the clamps are properly seated on the pins, tighten the
Phillips head screws until the clamp faces (
4
) are tightly secured against the bottom of the table.
5.
To prevent the screws from becoming loose, secure the wingnuts against the table clamp bodies.