Front panel features – Extron Electronics TLP Pro 720C Setup Guide User Manual
Page 7
7
Product Category
Front Panel Features
To see all the front panel features, remove the bezel, using the Extron Removal Tool. For a complete description of all these
features and their function, see the TLP Pro 720C User Guide.
A
A
D
D
E
E
C
C
B
B
F
F
G
G
A
Ambient light sensor — monitors ambient light level and adjusts screen brightness, based on the settings configured using
the
B
Bezel attachment point — The TLP Pro 720C has eight attachment points (two on each side, two on the top edge, and two
on the bottom edge).
C
LCD screen — the TLP Pro 720C has a 7 inch screen with a 800x480 resolution
D
Reset LED— indicates power status and reset status of the device.
E
Communication LED — shows the configuration and connection status of the touchpanel:
z
Unlit during normal operation (the touchpanel is configured and connected to an IP Link Pro control processor).
z
Blinks red if the touchpanel has been configured but is not connected to an IP Link Pro control processor.
z
Permanently lit if the touchpanel has not been configured and is not connected to an IP Link Pro control processor.
The indicator can be toggled between enabled and disabled, using the
(see page 8).
F
Reset button — this button allows the unit to be reset. The TLP Pro 720C has three reset modes that are initiated by
pressing the reset button. For full information about these different modes, see the TLP Pro 720C User Guide.
G
Menu button — activates the
and
H
Bezel — use the included removal tool to detach the bezel.
I
Speaker — one, placed inside the cable cubby, provides audible feedback for
the user.
J
Bezel removal slots — allow removal of bezel, using Extron removal tool.
K
Illumination LED — provides light for cable cubby enclosure.
H
H
J
J
K
K
I
I