Front panel operations, See “front panel operations, Preliminar y – Extron Electronics MTPX Series User Guide User Manual

Page 34: Operation, cont’d

Advertising
background image

Operation, cont’d

MTPX Twisted Pair Matrix Switchers • Operation

3-8

PRELIMINAR

Y

i

Audio button and LED — The Audio button and LED have two primary

functions (•) and five secondary functions (❏):
• Selects and deselects audio (or RS-232 if the wire pair is set for RS-232) for

a configuration that is being created or viewed.

• Lights to indicate that audio is available for configuration or viewing.

❏

Selects the Audio mode, in which you can adjust the input audio level and

the output audio volume. See “Viewing and adjusting the TP input audio

level” on page 3-26 and “Viewing and adjusting the local output volume”

on page 3-32.

❏

With the Enter button and Video button, selects between front panel

locks (Lock mode 2 and Lock mode 0). See “Setting the front panel locks

(Executive modes)” on page 3-40.

❏

With the Video button, selects between front panel locks (Lock mode 2

and Lock mode 1). See “Setting the front panel locks (Executive modes)”

on page 3-40.

❏

With the Video button, commands the front panel system reset.

See “Performing a system reset from the front panel” on page 3-41.

❏

Selects the RS-422 protocol for the rear panel Remote port in Serial Port

and Audio/RS-232 Input Configuration

mode and indicates the selection.

See “Selecting the rear panel Remote port protocol and baud rate” on

page 3-42.

Front Panel Operations

The following paragraphs detail the power-up process and then provide sample

procedures for the following actions:

• Creating ties, sets of ties, and configurations
• Changing a configuration
• Viewing ties, sets of ties, and configurations
• Muting and unmuting audio or RS-232 outputs
• Saving a preset
• Recalling a preset
• Viewing and adjusting the TP input audio level
• Viewing and adjusting the local output volume
• Defining the Audio/RS-232 wire pair
• Locking and unlocking the front panel
• Performing front panel resets
• Reading and setting the RS-232/RS-422 Remote port settings

Advertising